Meec tools 014093 Bedienungsanleitung Seite 9

● On products with multiple blades, all the blades can
move if one of the blades is turned. This can cause
personal injury.
● Do not use the product without the grass catcher or
the ejector opening guard correctly installed.
● Do not operate the product in closed areas to prevent
carbon monoxide to accumulate.
● The product must only be used in daylight, or in good
artificial lighting.
● Do not use the product when there is a risk of
lightning.
● Do not operate the product on wet grass.
● Do not run with the product.
● Use slip-resistant shoes and applicable clothing
during operation of the product.
● Make sure to have a correct footing during operation
on slopes.
● Mow across slopes, not up and down.
● Be very careful when you change direction on slopes.
● Do not mow very steep slopes.
● Be careful when you go backwards or pull the product
towards you.
● Stop the product when you move the product to and
from the area to be mowed or over surfaces without
grass.
● Stop the product before you tilt it.
● Do not use the product without the safety devices and
guards or if they are damaged or not correctly
attached.
● Do not change the speed governor setting or
overspeed the engine.
● Disengage and set all controls in neutral mode before
you start the product.
● Do not put your hands or feet near, or under, the
rotating parts of the product.
● Keep your feet away from the blade when you start the
product.
● Do not tilt the product when you start it, if not
necessary. If the product must be tilted, do not tilt it
more than necessary and do not lift the end nearest to
you.
● Do not stand in front of the ejector opening when you
start the product.
● Do not lift the product when it operates.
● Do not use the product if you are tired, ill, or
intoxicated. This will decrease your vision, alertness,
coordination and judgement.
● Do not let children or persons who do not know the
product to use it.
● Do not use the product if it is damaged.
● Do not make changes to the product.
● Use the product only for its specified function.
3 Assembly
3.1 To assemble the product
Warning! If you do not obey these instructions,
there is a risk of death or injury.
Note! Left and right position is specified when the opera-
tor stands behind the product
● 2 persons are necessary to lift the product out of the
packaging. Make sure that there is enough space to
put down the product.
1
Attach the bottom handle to the bracket of the
deck with a screw and a lock knob. (Figure 2)
2
Attach the top handle to the bottom handle with a
screw and a lock knob.
3
Attach the safety bail cable to the left bottom
handle with the clamp.
4
Pull the starter handle carefully towards the top
handle and pull out the starter cable until the
handle is just above the starter handle guide on
the right bottom handle. Then put the starter cable
through the starter handle guide. (Figure 3)
3.2 To attach the grass catcher
1
Lift the ejector opening guard (A) with one hand.
(Figure 4)
2
Attach the grass catcher to the ejector opening (B)
with the other hand.
3
Release the ejector opening guard to lock the
grass catcher in the position.
EN
SV
NO
DA
PL
DE
FI
FR
NL
9