Meec tools 014093 Bedienungsanleitung Seite 10

4 Operation
EN
Warning! Do not do adjustments on the product
SV the product operates..
4.1 To fill the engine oil tank
NO
Warning! Stop the product, remove the spark plug
cap and let all moving parts have come to a complete
DA
stop before you fill engine oil tank of the product.
Caution! The product is delivered without oil in
PL
the engine oil tank. Fill the engine oil tank with 4-stroke
engine oil before the first use to prevent damage to the
engine of the product.
DE
Caution! Change the engine oil after the first 5
FI hours of operation.
1
Put the product on a level surface.
FR
2
Loosen the oil cap and wipe the dipstick.
NL
3
Put the oil cap with the dipstick back but do not
tighten it.
4
Remove oil cap and do a check of the oil level on
the dipstick.
5
If the oil level is near or below the "Min" mark on
the dipstick, use a funnel and fill the engine oil
tank with engine oil.
Note! The oil level must be between the "Min" and "Max"
marks on the dipstick. Do not fill the engine oil tank
above the "Max" mark on the dipstick.
6
Tighten the oil filler plug.
7
Clean the product and the adjacent area from
spilled oil.
4.2 To refuel the product
Warning! Stop the product, remove the spark plug
cap and let all moving parts have come to a complete
stop before you refuel the product.
Warning! Be careful when you refuel because
petrol is highly flammable.
● The product is supplied without fuel. Refuel the
product before the first use.
10
● Store petrol out of the reach of children.
● Only refuel in a well-ventilated area.
● Keep petrol away from sparks and open flames. Do
not smoke near petrol or when you refuel.
● Do not breathe the petrol fumes and prevent to get
petrol on your skin.
● Use only clean and fresh unleaded petrol.
● Do not buy more petrol than you can use in 30 days.
● Do not mix the petrol with oil.
● Do not fill the fuel tank too much. Fill at a maximum to
the bottom edge of the filler pipe, so that the fuel can
expand.
1
Clean the area around the fuel cap to prevent dirt
to come into the fuel tank.
2
Open the fuel cap and do a check of the fuel level.
3
Fill the fuel tank with petrol if necessary. Be careful
not to spill.
4
Tighten the fuel tank cap.
5
Clean the product and the adjacent area from
spilled petrol if necessary.
4.3 To adjust the mowing height
The mowing height can be set between 20–70 mm.
1
Pull out the cutting height adjustment lever and
move it to the applicable position.
2
Release the lever to lock it in the applicable
position.
4.4 To do before each start of the
product
● Pull the safety bail bar again and again and make sure
that the wire moves easily.
● Make sure that the blades are correctly and safely
installed.
● Make sure that the spark plug lead is connected to the
spark plug.
● Make sure that the oil level is correct.
● Do a check of the fuel level and refuel if necessary.