Meec tools 014093 Bedienungsanleitung Seite 12

2
Start the product and let the engine operate until it
EN
stops. Make sure that the fuel tank is empty.
3
SV
Let all moving parts come to a complete stop.
4
Remove the spark plug cap.
NO
5
While the engine is warm, remove the engine oil
from the engine oil tank. Refer to "7.5 To change
DA
engine oil" on page 13.
6
If possible, put the product in its original
PL
packaging.
7
DE
Clean the product. Refer to "7.6 To clean the
product" on page 14.
FI
8
Safety the product to make sure it cannot move in
the vehicle.
FR
6 Storage
Warning! Do not keep the product with fuel in the
NL
tank in areas with heat sources.
● Keep the product in an area where children and pets
do not have access to it.
● Keep the product upright on a level surface.
6.1 To prepare the product before
it is put into storage for up to 2
weeks
1
Stop the product and let all moving parts come to
a complete stop.
2
Remove the spark plug cap from the spark plug.
3
Clean the product. Refer to "7.6 To clean the
product" on page 14.
6.2 To prepare the product before it
is put into storage for more than
2 weeks
Warning! Do not remove the fuel from the fuel tank
in a closed area, near open flames or other heat sources.
Do not smoke when you remove the fuel from the fuel
tank. Petrol and petrol fumes are highly flammable and
can be explosive.
Caution! If you do not obey these instructions it
can be difficult to start the product after it has been in
storage.
12
Caution! Change the engine oil at the end of every
season. Refer to"7.5 To change engine oil" on page 13.
1
Remove the fuel from the fuel tank. Use a fuel
pump.
2
Start the product and let the engine run until it
stops. Make sure that the fuel tank is empty.
3
.
Clean the product Refer to "7.6 To clean the
product" on page 14.
4
Put the product into a well ventilated area.
7 Maintenance
Warning! Stop the product, remove the spark plug
cap and let all moving parts have come to a complete
stop before you clean or do maintenance on the product.
Warning! If you do not know how to repair or do
maintenance to the product, refer to an approved person-
nel. Repairs that are not correctly done can result in the
risk of personal injury or damage to the environment.
● Follow the maintenance instructions to keep the
product in a good working condition.
● Do a check of the blades, blade screws and mower
deck for wear and damage before each use. Replace
damaged parts before use.
● If the blades or screws are worn or damaged, both the
blades and the screws must be replaced.
● Make sure that all screw unions are correctly
tightened to keep the product in safe condition.
● Keep the product free from grease, grass, moss, leaves
and equivalent to prevent fire risk.
● Do a check of the grass catcher for wear or damage at
regular intervals. If necessary, replace damaged
parts.
● Use original spare parts when the blades, fasteners
and bolts are replaced.