Post-Connection Check; Operating The Field Indicator; Quick Operation Guide - Endress+Hauser Rid14 Bedienungsanleitung

Operating the field indicator

5.4

Post-connection check

After the electrical installation of the device, always run the following final checks:
Device condition and specifications
Are cables or the device damaged (visual inspection)?
Electrical connection
Does the supply voltage match the specifications on the nameplate?
Do the cables used comply with the specifications?
Do the cables have adequate strain relief?
Are the power supply and signal cables correctly connected?
Are all the screw terminals well tightened and have the connections of the spring
terminals been checked?
Are all the cable entries installed, tightened and sealed? Cable run with "water trap"?
Are all housing covers installed and firmly tightened?
Are all the connection components (T-box, junction boxes, connectors, etc.) correctly
connected to one another?
Has each fieldbus segment been terminated by a bus terminator at both ends?
Has the max. length of the fieldbus cable, as defined in the fieldbus specifications, been
observed?
Has the max. length of the spurs, as defined in the fieldbus specifications, been
observed?
Is the fieldbus cable completely shielded (90%) and correctly grounded?
6 Operating the field indicator
6.1

Quick operation guide

Operators have two options for configuring and commissioning the device:
1. Configuration programs
Device-specific parameters are configured via the E+H Service interface (CDI). A special device
driver (DTM) for an FDT operating program (e.g. DeviceCare, FieldCare) is available for this
purpose →  41.
The DTM file is available for download via: www.endress.com/download → Enter product root
→ Media type "Software" and "Device drivers".
2. Miniature switches (DIP switches) for local configuration
38
RID14
Notes
-
Notes
9 to 32 V
DC
Fieldbus cable, see
Operating Instructions
-
→  34
-
-
-
-
-
see cable specifications in
the Operating Instructions
Endress+Hauser