Troubleshooting - Weatherdock easyTRX2 Handbuch

User's Manual

25. TROUBLESHOOTING

Problem
Unable to
connect to
easyTRX2
No data output
Entering MMSI
not possible
Weatherdock AG
Cause
USB cable
connected
correctly?
Device
configured
properly?
not connected
MMSI used
before?
Sigmundstraße 180
Tel.:+49 911 37 66 38 30
Solution
Install the Windows driver for the
USB serial interface (FTDI) from the
internet. (For Windows select the
„recommended" driver installation.)
Repeat configuration, if necessary
contact your service partner
Check connection; are cable colors
correct? Is the data output of the
easyTRX2 device connected with the
data input of the plotter?
Is the data rate of the NMEA port of
the plotter correct?
(necessary value 38400 baud!)
The MMSI cannot be programmed
twice. The device must be sent to the
main importer to reset the MMSI.
D-90431 Nürnberg
www.weatherdock.de
Page 114 of 125