Before Commissioning; Operation - Scheppach Cap150-4V Originalbetriebsanleitung

• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
9.

Before commissioning

Warning!
Do not use your product until it is completely assembled
and installed according to the instructions.
9.1 Charging the battery (Fig. 1)
• Switch the pump off at the On/Off switch (6).
• Insert the USB-C plug (13) into the USB-C port (7)
on the device.
• Connect the USB cable to the mains.
• The voltage indicator (8) illuminates during the charg-
ing process. As soon as the battery is fully charged,
the voltage indicator (8) illuminates.
• Unplug the USB cable again.
9.2 Fitting the compressed air hose and the adapt-
er set (Fig. 1)
• Screw the compressed air hose connector (12) into
the mount (2).
• Screw the required adapter (14, 15, 16) into the
mount on the compressed air hose (12).
9.3 Using the adapter set (fig. 4, 5)
The adapter set enables the following additional capa-
bilities:
• Using the ball needle to inflate balls (14).
• The Dunlop valve (16) enables bicycle tyres to be
inflated.
• It is possible to fill inflatable toys, sports equipment
and beach items using the conical adapter (15).
ATTENTION! When inflating objects with an air pres-
sure of 10 Psi or less, always inflate in short bursts. Af-
ter each burst, squeeze the object or use a calibrating
measurement device to check whether the required air
pressure has been reached.
26 | GB
ATTENTION! The air pressure required to inflate most
sports balls is too low to be read out accurately on the
device's measurement indicator.

10. Operation

m Attention!
Always make sure the product is fully assembled
before commissioning!
10.1 Switching on/off (fig. 1, 2)
• Press and hold the On/Off switch (6) for 3 seconds
to switch on.
• Press the operating mode button (11) to switch to the
required inflation mode.
• By pressing the operating mode button (11) again, the
desired unit of measurement (bar, kPa, PSI) can be
selected on the display.
• Press and hold the On/Off switch (6) for 3 seconds to
switch the device off.
10.2 Adjusting the pressure (Fig. 1, 2)
The pressure can also be regulated using the "+" (5) and
"-" (10) buttons.
The "+" button can be used to increase the pressure.
The "-" button can be used to decrease the pressure.
10.3 Inflate (Fig. 1, 2)
• Press the On/Off switch on the pump (4) to start the
inflation process.
• The pump stops automatically as soon as the pre-set
pressure is reached.
• It can also be stopped by pressing the On/Off button
on the pump (4) again.
• After inflating, first remove the adapter (14, 15, 16)
from the compressed air hose and then pull the com-
pressed air hose (12) off the device.
10.4 LED work lamp (Fig. 1)
This product is equipped with an LED work lamp (1) to
illuminate the immediate work area and improve visibility
in poorly lit environments.
CAUTION! Do not look directly into the LED work lamp
or the light source.
1 Press the LED button (9) again for a short time to
switch the LED work light (1) on.
2 Pressing again causes the light to flash in SOS mode.
www.scheppach.com