Installing The Versarails Slide Assemblies - Dell PowerEdge 1750 Installationsanleitung

Installing the VersaRails Slide Assemblies

At the front of the rack cabinet, position one of the VersaRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape (or numbered location) on
the rack (see Figure 1-6).
The three holes on the front of the mounting bracket should align with three of the
holes between the marks you made on the front vertical rail.
Install two 10-32 x 0.5-inch flange-head Phillips screws in the mounting flange's top
2
and bottom holes to secure the slide assembly to the front vertical rail (see Figure 1-6).
At the back of the cabinet, pull back on the mounting-bracket flange until the
3
mounting holes align with their respective holes on the back vertical rail.
Install three 10-32 x 0.5-inch flange-head Phillips screws in the back mounting holes to
4
secure the slide assembly to the back vertical rail.
F i g u r e 1 - 6 . I n s t a l l i n g t h e V e r s a R a i l s S l i d e A s s e m b l i e s
slide assemblies (2)
mounting-bracket flange
10-32 x 0.5-inch
flange-head Phillips
screws (5 per slide
assembly)
front of rack
Rack Installation Guide
1-9