Installing The Rapidrails Slide Assemblies; Marking The Vertical Rails - Dell PowerEdge 1750 Installationsanleitung

Place a mark 44 mm (1.75 inches) above the original mark you made (or count up
2
three holes in a rack that meets EIA-310 standards) and mark the rack's front vertical
rails with a felt-tipped marker or masking tape (if you counted holes, place a mark just
above the top hole).
This mark or piece of tape indicates where the system's upper edge will be located on
the vertical rails (see Figure 1-4).
F i g u r e 1 - 4 . M a r k i n g t h e V e r t i c a l R a i l s
tape on
vertical rail

Installing the RapidRails Slide Assemblies

At the front of the rack cabinet, position one of the RapidRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape you placed on the rack (see
Figure 1-5).
The mounting hook on the slide assembly's front mounting bracket flange should
enter the top hole between the marks you made on the vertical rails.
Push the slide assembly forward until the mounting hook enters its respective square
2
hole on the vertical rail, and then push down on the mounting-bracket flange until the
mounting hooks seat in the square holes and the push button pops out and clicks.
Rack Installation Guide
1-7