Installing the VersaRails Assemblies
1 At the front of the rack cabinet, place a VersaRails assembly so that its
mounting-bracket flange fits between the marks or tape (or numbered
location) on the rack (see Figure 1-6).
The holes on the front of the mounting bracket should align with the holes
between the marks on the front vertical rail.
NOTE:
required for this system.
2 Locate the round mounting hole indicated by the tooled arrow cutout
on the VersaRails (see Figure 1-6).
3 Install two 10-32 x 0.5-inch flange-head Phillips screws in the front
mounting flange to secure the rail assembly to the front vertical rail.
See Figure 1-6.
•
The upper mounting screw should be installed in the middle round
hole of the 6th-U space counting up from the bottom of the 10-U
space.
•
The lower mounting screw should be installed in the middle round
hole of the 1st-U space counting up from the bottom.
NOTE:
your system to the rack. To assemble the VersaRails, use only the round holes
indicated by the two tooled arrow cutouts (see Figure 1-6).
4 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting holes align with their respective holes on the back vertical
rail.
5 Install two 10-32 x 0.5-inch flange-head Phillips screws in the back
mounting flange to secure the rail assembly to the back vertical rail.
6 Repeat step 1 through step 5 for the rail assembly on the other side
of the rack.
NOTE:
sides of the rack.
16
Rack Installation Guide
The VersaRails occupy only the lower 6-U of the 10-U space that is
The two midsection round holes on the VersaRails are for securing
Ensure that the rails are mounted at the same vertical position on both