Fuxtec FX-RM5170PRO Bedienungsanleitung Seite 47

Temperature
<0℃
0℃ - 10℃
10℃ - 20℃
>20℃
Important note: not every model is equipped with a primer pump.
To start the engine, tighten the handle for the engine cable to the handle of the upper spar.
If your model has rear-wheel drive, you should not hold the handle for the rear-wheel drive during
the starting process. Otherwise, the rear wheels will start moving immediately.
Then pull carefully on the handle of the starter cable until you feel a slight resistance. Now pull the
starter rope with momentum to start the engine. With a cold start, you may need 2-3 attempts until
the engine runs.
Manual_FX-RM5170PRO_Int24 _rev3
Pressing the primer
pump
3x - 4x
2x - 3x
1x - 2x
1x
Handle starter cable
47