Parkside Performance PPRDS 20-Li C3 Bedienungs- Und Sicherheitshinweise Seite 51

Properly tighten the spray tank cover
after pouring liquids into the spray
tank.
Use only consumer-grade
water-based chemicals.
Do not use alkali self-heating or
corrosive liquids with the product.
These can corrode metal parts or
weaken the tank and hose.
Do not leave residue or spray
material in the spray tank after using
the product. Clean the product after
each use.
Do not add liquids with a
temperature of more than 5 C to
avoid damaging the hose or spray
tank.
Do not overfill the tank.
Do not operate the product in narrow
or enclosed spaces. Always spray in
a well-ventilated area Do not smoke,
eat or drink while using the product.
Do not smoke in areas where the
product is used.
Always wear appropriate personal
protective equipment (see
"Preparation" "Accessories" .
Contact an e pert for specific
information about personal protective
equipment.
Do not discharge the spray materials
directly against skin.
Aim the nozzle directly at the plants
or objects intend to spray.
Ensure that the spray materials are
directed at an area that will not be
damaged by the spray materials.
Electric shock hazard! Do not spray
towards electric outlets.
After every use, thoroughly wash
your hands and any area where
skin has been exposed to the spray
materials.
Remove the battery pack from the
product before draining, cleaning
or storing the product to avoid
accidental starting.
Thoroughly inspect both the inside
and outside of the product and
examine all components before each
use.
Check for cracked and deteriorated
hoses, leaks, clogged nozzles, and
missing or damaged parts.
A damaged hose or loose hose
connection can result in accidental
contact with the spray solution,
causing serious injury or property
damage.
If damaged, have the product
repaired before use. Many accidents
are caused by poorly maintained
products.
Do not lift or carry the product by
the hose or shut o valve. Carry
the product by the handle and the
shoulder strap only.
Never use the product in a room
where there is a danger of explosion
or in the vicinity of ammable li uids
or gases.
Do not immerse the product in water
or other liquids. Do not place the
product where it can fall or be pulled
into a tub or sink.
Only operate the product when it is
in an upright position.
Do not operate the product with an
empty spray tank.
It is necessary to provide the
appropriate training in safe operation.
Do not use the product while tired,
ill or under the in uence of alcohol,
drugs or medicaments.
Always carry out a visual inspection
before using the product. Do not use
the product if it is damaged. If the
product is damaged, have it checked
by ualified personnel.
Always check the product for leaks.
If any are found, correct them before
using the product.
GB/IE 49