Parkside Performance PPRDS 20-Li C3 Bedienungs- Und Sicherheitshinweise Seite 49

3. Prevent unintentional starting.
Ensure the switch is in the
‑ i i
power source and/or battery pack,
picking up or carrying the tool.
Carrying power tools with your finger
on the switch or energising power
tools that have the switch on invites
accidents.
4. Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left
attached to a rotating part of the
power tool may result in personal
injury.
5. Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
6. Dress properly. Do not wear loose
clothing or jewellery. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewellery or long hair can be caught
in moving parts.
7. If devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of dust collection can reduce
dust-related hazards.
8. Do not let familiarity gained from
become complacent and ignore
tool safety principles. A careless
action can cause severe injury within
a fraction of a second.
Power tool use and care
1. Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
2. Do not use the power tool if the
switch does not turn it on and
i
be controlled with the switch is
dangerous and must be repaired.
3. Disconnect the plug from the
power source and/or the battery
pack from the power tool before
making any adjustments, changing
accessories, or storing power
tools. Such preventive safety
measures reduce the risk of starting
the power tool accidentally.
4. Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
5. Maintain power tools and
accessories. Check for
misalignment or binding of moving
parts, breakage of parts and any
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
6. Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
7. Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations
di erent from those intended could
result in a hazardous situation.
Any power tool that cannot
i i
GB/IE 47