Herunterladen Diese Seite drucken

Cleanfix RA435 IBC VDE Bedienungsanleitung Seite 39

Vorschau ausblenden Andere Handbücher für RA435 IBC VDE:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Maintenance suction
nozzle
38
Battery maintenance
Wet batteries
Maintenance free
batteries
Li-Ion batteries
www.cleanfix.com
The wiper blades on the suction nozzle wear out over time but can be used on all four
sides if they are turned early enough. It must be ensured that the wiper blades are not
worn over the center. (See Fig. 21, page 38)
For the front wiper blade, loosen the corresponding screw (1) with a 5mm allen key to
loosen the retaining plate (2) and remove it. Remove the wiper blade (3) and turn it
accordingly so that a sharp edge points to the front and mount the retaining plate
again. (Fig. 24)
To change the rear wiper blade, loosen the quick-release lever (4), remove the
retaining plate (5) and also turn the blade (6) so that a sharp edge also points to the
front. Mount the retaining plate and close the quick-release lever again. (Fig. 25)
1
3
2
• maintenance intervals according to the manufacturer and follow the instructions
and regulations.
• Overfilling the batteries will cause corrosion damage to the ride-on machine.
• We recommend maintenance-free batteries.
• Only use the charging curve recommended by the manufacturer for charging.
(see p. 31)
• Only load the machine when it is open and in a well-ventilated area.
Explosion warning!
• Carry out maintenance according to the manufacturer and follow the instructions
and regulations.
• If the batteries are not used for a longer period, it is recommended to remove them
and store them at a temperature of 20°C - 25°C. The optimum chargingtemperature
is between 5°C and 40°C.
• Are not allowed!
Batteries can go into deep charge if not used for a long time and can then no
longer be recharged! Batteries should therefore be recharged monthly!
24
25
39
4
6
5
435.042

Werbung

loading

Diese Anleitung auch für:

435.015-old