Herunterladen Diese Seite drucken

Cleanfix RA435 IBC VDE Bedienungsanleitung Seite 37

Vorschau ausblenden Andere Handbücher für RA435 IBC VDE:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Mount / replace brush
37
Maintenance and cleaning
www.cleanfix.com
Push the brush or drive plate with centrally fixed pad under the brush drive, press
upwards and turn against the direction of brush rotation until it engages.
(Fig. 17 + 18)
The bristle length of the brushes and the thickness of the pads must not be less than
1 cm. If the bristles are too short or the pads too thin, the floor covering may be
damaged. Check the brushes and pads regularly before starting work!
Only the brushes, drive plates and pads intended for the appliance may be used. The
use of other cleaning agents may impair safety.
assembly
→ Switch off the machine before maintenance and cleaning.
→ Cleaning the scrubber dryer with a high-pressure cleaner or a hose can lead
to considerable damage and is therefore prohibited.
→ Maintenance and repairs to the mechanical system may only be carried out
by authorized service centers.
• Clean the outside of the device with a sponge or cloth.
• Empty the dirty water tank as described on page 36.
• Rinse the dirty water tank thoroughly with a hose. Leave open the tank cap (A) to
dry out so that bad odors can be avoided. odor can be avoided. (Fig. 19, page 38)
• Remove the suction nozzle (9, Fig. 20, page 38) and clean it under running water
with a brush or sponge. Check the blades for wear and replace them if necessary.
Make sure that the suction lips are not worn over their center. This is the only way
to use them on all four sides by refitting them in reverse. (Fig. 21, page 38)
• Loosen the suction hose at the top (20, Fig. 20, page 38) and rinse it from above. If
necessary, empty the fresh water tank (see page 36)
Clean nozzles and fins with gloves - risk of injury!
disassembly
17
37
18
435.042

Werbung

loading

Diese Anleitung auch für:

435.015-old