Herunterladen Diese Seite drucken

Cleanfix RA435 IBC VDE Bedienungsanleitung Seite 36

Vorschau ausblenden Andere Handbücher für RA435 IBC VDE:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Drainage wastewater
Drainage fresh water
www.cleanfix.com
A float (5, Fig. 14) is fitted in the dirty water tank, which lifts a ball in front of the
suction when the tank is full and closes it. This can be detected acoustically when the
suction motor revs up and the suction power stops. Switch off the machine
immediately and empty the recovery tank as described below.
→ Switch off the machine and lift the brush head.
→ Drive the scrubber-drier to the appropriate emptying point. Advantageous in Sink
with sewer connection.
→ Uncouple the drain hose (18, Fig. 15), hold it up, unscrew the sealing cap and
bend the hose at the sealing cap.
→ Lower the drain hose to the drain point, loosen the kinked hose, empty the waste-
water tank and flush it with clean water.
When emptying into buckets, this can be interrupted by lifting the emptying hose in
good time or by kinking the hose. After emptying, screw the lid back on tightly and put
the emptying hose back into the hose holder.
In the event of foam and/or water escaping from below the tank or tank cap,
the machine must be switched off and emptied immediately.
Observe national regulations for the disposal of wastewater. The user is
responsible for compliance without restriction!
5
If the machine is not used for a longer period, also empty the freshwater tank to
prevent odors from forming. Proceed as follows to do this:
→ Switch off the machine.
→ Drive the scrubber-drier to the appropriate emptying point. Advantageous in Sink
with sewer connection.
→ Unscrew the screw cap (23, Fig. 16) under the machine at the left wheel, drain the
fresh water and screw the lid back on hand-tight screw on again.
23
18
14
16
36
15
435.042

Werbung

loading

Diese Anleitung auch für:

435.015-old