Werbung
Verfügbare Sprachen
Verfügbare Sprachen
■
Take batteries/rechargeable batteries out of the device if you are not going to
use it for longer periods.
ATTENTION: Risk of damage to the product
■
Only use the stated type of batteries/rechargeable batteries!
■
Insert the batteries/rechargeable batteries in the product and make sure the
polarity (+) and (-) is correct.
■
Clean the contacts of batteries/rechargeable batteries and those in the battery
compartment with a dry, lint-free cloth or cotton swab before inserting them.
■
Immediately remove spent batteries/rechargeable batteries from the product.
■
The correct polarity is indicated in the battery compartment.
● Start-up
Note: Remove all packaging material from the product. Remove all protective
films before first use.
Note: Ensure sufficient ventilation of the product and keep the ventilation slots
free from obstruction 4 .
The battery supplied has already been inserted in the product. It is protected from
discharging by means of a battery isolation strip. This battery isolation strip must
be removed before the first use.
□
Pull the battery isolation strip out of the battery compartment 6 .
All elements appear on the display 1 for approx. 3 seconds. Then the currently
measured values are displayed.
● Setup
□
Place the product on a level surface with the stand folded out 5 .
● Wall mounting
Note: Do not install the product higher than 2m above ground.
The product is also designed for wall mounting (loop 2 ) and can be attached
using suitable assembly material (not included). Please observe the conditions on
site.
Safety / Start-up / Setup / Wall mounting
GB/IE/NI
11
Werbung
