Numark DJ2GO2 Benutzerhandbuch Seite 47

Setting Up DMX Fixture
Step 3: Patching Fixtures
Once you have found the fixture, select the mapping which
matches the DMX Mode you set on your fixture.
Then drag and drop the mapping onto the DMX Universe Map and
position the mapping on the same DMX Address you have set on
your fixture.
For example, if you have set the fixture to DMX address 1 , drag the
mapping and place it on 1 in the DMX Map
If your Fixture is set on a different DMX Address, make sure to
place your mapping on the correct address.
Remember to make sure fixtures are not crosspatched.
SoundSwitch will indicate if you have crosspatched a fixture by
turning the DMX icon yellow and in the DMX map as shown below:
Continue to add fixtures until all of the fixtures in your rig have
been patched.
12