VEVOR R0800C Bedienungsanleitung Seite 9

- Maintain a firm grip on the power tool and position your body and arm to
allow you to resist kickback forces. Always use auxiliary handle, if
provided, for maximum control over kickback or torque reaction during
start-up. The operator can control torque reactions or kickback forces, if
proper precautions are taken.
- Never place your hand near the rotating accessory. Accessory may
kickback over your hand.
- Do not position your body in the area where power tool will move if
kickback occurs. Kickback will propel the tool in direction opposite to the
wheel's movement at the point of snagging.
- Use special care when working corners, sharp edges etc. Avoid
bouncing and snagging the accessory. Corners, sharp or bounced edges
have a tendency to snag the rotating accessory and cause loss of control
or kickback.
- Do not attack a saw chain woodcarving blade or toothed saw blade.
Such blades create frequent kickback and loss of control.
SAFETY WARNINGS SPECIFIC FOR GRINDING AND
ABRASIVE CUTTING-OFF OPERATIONS
-Use only wheel types that are recommended for your power tool and the
specific guard designed cannot be adequately guarded and are unsafe.
-The guard must be securely attached to the power tool positioned for
maximum safety, so the least amount of wheel is exposed towards the
operator. The guard helps to protect operator from broken wheel
fragments and accidental contact with wheel.
- Wheels must be used only for recommended applications. For example:
do not grind with the side of cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied to these wheels may
cause them to shatter.
- Do not restart the cutting operation in the work piece. Let the wheel
reach full speed and carefully reenter the cut. The wheel may bind, walk
up or kickback if the power tool is restarted in the work piece.
- Support panels or any oversized work piece to minimize the risk of wheel
pinching and kickback. Large work pieces tend to snag under their own
weight. Supports must be placed under the work piece near the line of cut
and near the edge of the work piece on both sides of the wheel.
-Use extra caution when making a "pocket cut" into existing walls or other
blind areas. The protruding wheel may cut gas or water pipes, electrical
— 7 —