VEVOR R0800C Bedienungsanleitung Seite 11

with both hands.
- Secure the work piece. A work piece clamped with clamping devices or
in a vice is held more secure than by hand.
- Keep your workplace clean. Blends of materials are particularly
dangerous. Dust from light alloys can burn or explode.
- Never use the machine with a damaged cable. Do not touch the
damaged cable and pull the mains plug when the cable is damaged while
working. Damaged cables increase the risk of an electric shock.
ASSEMBLY
WARNING!
Switch off the die grinder and disconnect it from the power point.
NOTE:
Make sure the main voltages match on the machine's rating label.
FITTING THE GRINDING POINT
- Insert the grinding points which on the hole of the central spindle (2) then
adjust the grinding point to the fit position distance away from the edge of
the spindle.
- Rivet the spindle with second spanner then tighten the collect nut firmly
in clockwise direction using the spanner.
Make the die grinder run in idle for at least a minute with the grinding point
correctly assembled, the grinding point should be immediately replaced if
there is the vibration.
— 9 —