Maintenance And Inspection - Vevor R0800C Bedienungsanleitung

OPERATING INSTRUCTION
NOTE:
The die grinder can be used for grinding steel or ceramic work pieces such
as pipe, box section, rectangular, angle iron steel bar, should, household
bricks and tiles. Don't attempt to grind a soft metal such as lead. The
material will quickly "fill" the disc and render it useless. Before starting the
grinder first ensure that the grinding point, collet nut and tool are in good
condition. Do not cover ventilation when the tool is in use. This may cause
damage to the motor and reduce the efficiency of the tool.
GRINDING
The best results are achieved with an angle of 0 to 30 for grinding. Move
the machine left and right with light pressure. In this manner, the work
piece does not become too hot, no discoloration occurs and no ridges are
produced.
CAUTION!
When begin the operating, must be grind with the little press, and touch
the small area of work piece, then increase the press stepwise under rated
power.

MAINTENANCE AND INSPECTION

WARNING!
Regular inspection and maintenance the part of mechanical of the
machine each 100 hours, such as spindle, bearing etc., and if they are not
agility, add the greasing to them replacing them in the authorized service
agent if the bearing damaged.
Always be sure that the tool is switched off before attempting to perform
inspection or maintenance.
- The armature and stator is the heart of the power tool. Exercise due care
to ensure they don't become damaged or effected by oil or water.
- The carbon brushes should be checked periodically and worn out carbon
brushes should be replaced in time. After replacing. Inspect whether the
new carbon brushes can move freely in the brush holder.
Keep running the motor for 15 minutes to match the contact of the carbon
brushes and commutator.
— 11 —