Sleep Function - geo-FENNEL FL 115H Bedienungsanleitung

V-W-S MODE (VIBRATION-WIND-SECURITY)
Press the key , to switch on the V-W-S mode. A red LED will show that this mode is activated. The
V-W-S mode allows continuous operation during strong wind, vibrations and shocks. Slight movements
will be ignored, only if significant movement occurs the laser stops rotating as the V-W-S mode works
with the activated TILT function. Press the key again to switch this mode off.
SLOPE FUNCTION
This mode can only be operated with the remote control:
Press the key once to tilt the X axis with buttons (1) (LED of X axis on the instrument is blinking).
Press the key twice to tilt the Y axis with buttons (1) (LED of Y axis on the instruments is blinking.
Press the key to quit the slope function. The
Important: If the slope angle is beyond the self-levelling range the slope process stops and an alarm
signal sounds.
When it is in SLOPE mode the unit will automatically leave the TILT mode.
SHIELD FUNCTION
With the buttons (I) of the instrument or (4) of the remote control the laser beam can be shielded in
all four directions - however, in max. three directions at the same time. This avoids that several laser
instruments on one construction site may disturb each other.

SLEEP FUNCTION

In order to save energy the laser beam and rotation can be powered off by pressing button
remote control (the ON/OFF LED and the TILT LED will power off). To resume, the laser beam
and rotation can be startet by pressing this button again.
SLOPE up/down key
Important: During sleep mode only the button
strument are available. After 30 min. in sleep mode the unit will auto power off. When leaving the sleep
mode the previous modes will maintain. It is not possible to power the unit on/off completely with the
remote control.
+X
+Y
SLOPE key
SLOPE TILT
TILT key
CALIBRATE
Direction key of
self-calibration
Figure 7: operation panel of remote control
LED will power off.
SLOPE up/down key
SLOPE key
TILT key
-Y
Shield key
Direction key of
-X
self-calibration
Sleep key
on the remote and the POWER switch on the in-
Confirm key of
self-calibration
Adjust key of
self-calibration
+X -Y
+Y -X
on the
SLOPE TILT
CALIBRATE
Figure 7: operation panel of remote control
EN
Shield key
Sleep key
Confirm key
self-calibrati
Adjust key o
self-calibrati
27