Tilt Function - geo-FENNEL FLG 265HV-GREEN Bedienungsanleitung

EN
ON / OFF BUTTON (2)
Press this button to power on and off the unit. If the red LED (1) lights the instrument is powered on.
After powering on the instrument the self-levelling procedure starts automatically. Thereafter, the laser
will rotate with 800 rmp.
If in normal use the LED (1) flashes the battery has to be recharged.

TILT FUNCTION (3)

After POWER ON the laser automatically activates the TILT function. The TILT LED (4) is flashing
during the activation procedure. When it is completed (after 90 sec. approx.) the LED is illuminated.
If the laser is disturbed rotation stops and the laser beam and TILT LED (4) will flash. The laser will
not re-level automatically.
To quit the TILT function press button (3).
If the laser is disturbed due to a positional change of the tripod it will automatically self-level (within the
self-levelling range of 5°); a height offset can occur. This will be avoided by using the TILT function. The
use of this function ensures that the laser is shut off even within the self-levelling range if the laser is
disturbed. Power on the unit and wait until the self-levelling procedure is completed.
ON / OFF REMOTE CONTROL FUNCTION - INSTRUMENT BUTTON (5)
With this button the remote control function can be powered off in order to avoid that several units on
one construction site disturb each other. If the remote control LED is illuminated it is the remote control
function is ready-to-receive.
LED REMOTE CONTROL - INSTRUMENT LED (6)
If the LED is illuminated the the remote control function is ready-to-receive.
ROTATING SPEED - INSTRUMENT BUTTON (8)
The instrument standardly rotates with max. speed (= 800 rpm). Press button (8) to change as follows:
800 rpm -> 300 rpm -> 0 rpm -> rpm.
LASER DOT FUNCTION
Rotating speed 0 rpm = laser dot function. Choose the direction of the laser dot with button (17).
VIBRATION-WIND-SECURITY FUNCTION (V-W-S) (9)
Press button (9) to activate the V-W-S function. The V-W-S LED (10) is illuminted and the TILT LED (4)
starts flashing. When the V-W-S LED (10) and the TILT LED (4) are both illuminated the V-W-S function
is activated. The V-W-S function automatically activates the TILT function. This function allows conti-
nuous operation during periods of vibration and wind. If a significant movement occurs the laser stops
rotating and the TILT LED (4) and the laser beam start flashing. Press the V-W-S button (9) to quit.
Press the V-W-S button (9) once again for re-activation.
35