Cochlear Baha Attract System Benutzerhandbuch Seite 3

Welcome
Congratulations on getting your Cochlear™ Baha
provides tips and advice on how to best use and care for your Cochlear Baha Attract
System. It is a complement to the sound processor manual part A and does not
replace it.
Introduction
This guide includes instructions on:
• attaching your sound processor to the
SP magnet
• care, cleaning and maintenance
• using accessories
• troubleshooting.
Note
Fig. 1–9 can be found on the inside
of the cover of this user manual, the
figures correspond to sections of
information in this manual which is
general for all Baha sound processors.
The sound processor images shown are
representative only and not to scale.
The appearance of the sound processor
included in your kit may vary.
Cochlear Baha Attract System user manual part B
Attract System. This manual
®
Attaching your sound
processor and SP magnet
See Fig. 1–4. The SP magnet attaches to your
sound processor to keep it in place over the
implant magnet and to transfer sound from
your sound processor to the implant.
Use the tilt technique (described below)
to connect and disconnect your sound
processor from the SP magnet. This will
ensure it remains in good working order.
1. Place the SP magnet on a flat surface.
2. Gently tilt and snap the sound
processor into the SP magnet coupling.
Ensure you align the button(s) on the
sound processor with the arrow mark
on the SP magnet.
3. With the button(s) and arrow mark facing
upwards, place the sound processor
over the implant behind your ear. It may
be easier to turn the sound processor
on before you place it behind you ear.
4. Remove the sound processor by
grasping the SP magnet with the sound
processor still attached. To remove the
sound processor from the SP magnet,
place one finger under the sound
processor and gently tilt until it releases.
English
3