Bosch ErgoMix MSM6 Serie Gebrauchsanleitung Seite 125

■ Hold down both release buttons and
remove the whisk with the gear
attachment from the base unit.
■ Remove the whisk from the gear
attachment.
Multifunction accessory
The multifunction accessory is suitable for
cutting and shredding food.
W Risk of injury from sharp blades/
rotating drive!
Never reach into the bowl while the
appliance is operating. Always use the
pusher to add ingredients. After switching
off, the drive continues running for a short
time. Change tools only when the drive is at
a standstill.
When working with the multifunction
accessory, the base unit may only be
switched on when the lid has been fitted
and screwed on tight.
Warning!
Multifunction accessory must be completely
assembled before use!
Operation
Caution!
Before cutting up meat, remove gristle,
bones and sinews.
The multifunction accessory is not suitable
for cutting up very hard food (coffee beans,
radishes, nutmeg) or frozen food (fruit,
etc.).
Warning!
Always observe the maximum quantities
and processing times in the table. X Fig. G
After each operation cycle allow the
appliance to cool down to room
temperature.
Universal blade
For cutting up meat, hard cheese, onions,
herbs, garlic, fruit, vegetables, nuts and
almonds.
W Risk of injury from sharp blade!
Do not touch the sharp edges of the
universal blade with bare hands.
Take hold of the universal blade by
the plastic handle only. Clean with a
brush.
X Fig. D
■ Place bowl on a smooth and clean work
surface.
■ Insert universal blade.
■ Add food.
Warning!
Universal blade must be positioned upright
in the bowl so that the lid fits correctly
(Fig. D-3).
■ Place the lid on the bowl and turn all the
way anticlockwise.
Note: If fitting the lid is a bit stiff, turn the
three-piece coupling on the underside
of the attachment slightly and try again.
■ Place the base unit on the attachment
and lock into position. ■ Insert the
pusher.
■ Insert the mains plug.
■ Hold the base unit and multifunction
accessory firmly and switch on the
appliance (turbo setting).
■ To add more ingredients, release the On
button. Wait until the tool comes to a
standstill.
■ Remove the pusher and add ingredients
through the filling opening.
■ Release the On button after processing.
After using the appliance:
■ Disconnect the mains plug.
■ Press the release buttons and remove the
base unit from the attachment.
■ Turn lid clockwise and remove from the
bowl.
■ Take hold of the universal blade by the
plastic handle and remove.
en
21