Silvercrest SDB 2200 D2 Bedienungsanleitung Seite 9

Plugging in and ironing
Dry ironing is possible at all temperatures, steam ironing
is possible by adjusting to
thermostat 8.
• Insert the plug into a power socket.
Attention! Property Damage!
Should the clothing care instructions forbid ironing, (sym-
bol ), the clothing item may not be ironed.
If you do so, the clothing item could be permanently da-
maged.
• Check the care instructions on the labels in the gar-
ment to see whether it is suitable for being ironed,
and at which temperature setting.
Symbol thermostat 8
• Select the best suitable temperature setting with the
thermostat 8.
Note:
While it is heating up, always place the iron on the
base 0.
If you place the iron on the ironing sole q and do not
move it, the automatic switch-off will be activated after
30 seconds (see chapter "Automatic switch-off") and
the appliance stops heating.
The temperature control lamp 7 glows. When the set
temperature has been reached, the temperature control
lamp 7 goes out.
on the
Type of material
Acrylic, rayon
Silk, wool, polyester
blended fabrics
Cotton, linen, viscose
• Wait until the temperature control lamp 7
switches off.
• To moisten the laundry, press the button for fine wa-
ter spray 5.
This function is suitable for extremely dry and extremely
crumpled garments.
Steam ironing
• Set the steam regulator 3 to the desired steam set-
ting.
• The thermostat 8 must be moved to at least
adjustment range
ce any steam.
Ironing with steam blast
The steam blast is especially suitable for smoothing
parts of a garment that are difficult to reach.
• Slightly raise the steam iron.
• For a steam blast, press the steam blast
4.
button
Temporarily setting the steam iron
aside
Risk of fire!
NEVER leave the hot, mains-connected or switched-on
steam iron unattended.
• Set the thermostat 8 to the "MIN" position.
• Always put the steam iron on the appliance
base 0.
- 6 -
. Otherwise it cannot produ-