Werbung
and so on. To turn o
the lights, hold the button down or 2 seconds. The
front light is below the battery and the two rear lights, on either side of the
stand rame. ( ee fig. 26a, 26b, 26c)
BATEC AIR
To turn on the front and tail lights of the HANDBIKE BATEC ELECTRIC, press and
hold the button
for 1 second. When the lights are on, the brightness of the
▲
LCD screen will dim to prevent visual discom ort during night-time use. To turn
o the lights, press and hold the button
for 1 second, and the LCD screen
▲
brightness will return to its normal level. The ront light is below the battery and
the two tail lights, on either side o the stand rame. ( ee fig. 26A, 26B, 26c)
4.8. SIN THE HANDBIKE BATEC ELECTRIC
AD AIR / MINI 2 /
ELECTRIC 2 (RAPID 2) / SCRAMBLER 2 CONTROLS
You can nd out the meaning o all the symbols used on the controls o the
HANDBIKE BATEC ELECTRIC MINI 2, ELECTRIC 2, RAPID 2 and SCRAMBLER 2 in
Figure 58, and for the AIR in Figure 58A, with their respective positions in Figures
58B, 58C, 58D, 58E and 58F.
4.8.1. T RN ON
BATEC MINI 2, ELECTRIC 2, RAPID 2, SCRAMBLER 2
Turn the key on the right side of the battery clockwise to the ON position. It will
do a system check: don't start using your HANDBIKE BATEC ELECTRIC until it has
nished with the system check and all the lights are on. ( ee fig. 27)
IMPORTANT!
For the sa ety check to be completed properly, the wheel o the HANDBIKE BATEC
ELECTRIC must be stationary and the user must apply the brake lever on the
throttle side at least once. ( ee fig. 22B a d 22C)
BATEC AIR
• Before switching on the battery, ensure it is properly connected and secured
with the key.
• Press the "I" button on the battery to turn on the HANDBIKE BATEC ELECTRIC AIR.
• Then, press the "M" button on the display panel to switch on the TFT screen.
( ee fig. 27A)
– 22 –
Werbung
