The Temperature In The Appliance Is Too Low; Technical Data - IKEA FRAMTID Bedienungsanleitung

ENGLISH
Problem
Water flows on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the Af-
ter Sales Centre. You can find the list at the end
of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Remove the
screw from the
lamp cover.
2. Pull outwards
the rear hook of
the lamp cover
by using a
screwdriver
and remove the
lamp cover
pulling downwards.

Technical data

Dimensions
Height
Width
Depth
Net Volume
Fridge
Freezer
Defrost System
Fridge
Freezer
Possible cause
the The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
1800 mm
695 mm
661 mm
323 Litre
78 Litre
auto
auto
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
3. Replace the lamp with one of the same
power and specifically designed for house-
hold appliances. (the maximum power is
shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Star Rating
Rising Time
Freezing Capacity
Energy Consumption
Noise Level
Energy Class
The technical informa-
tion are situated in the
rating plate on the in-
ternal left side of the
appliance and in the
energy label.
12
20 hours
4 kg/24h
0,890 kWh/24h
44 dB (A)
A+