The Temperature In The Appliance Is Too Low - IKEA LFC186/44 Bedienungsanleitung

ENGLISH
Problem
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the Af-
ter Sales Centre. You can find the list at the end
of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Possible cause
The plug is not connected to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
Solution
Connect the plug to the mains
socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
Set a higher temperature.
Do not keep the door open lon-
ger than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover.
3. Replace the
lamp with one
of the same
power (the
maximum pow-
er is shown on the lamp cover).
4. Install the lamp cover.
11