Control Panel - IKEA FRAMTID Bedienungsanleitung

ENGLISH
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.
• This product must be serviced by the After
Sales Service, and only genuine spare parts
must be used. The service numbers are listed
in the Service information.

Control panel

1
1 Fan function switch
Fan light
2 Temperature regulator
Fast Freeze button
3 Fast Freeze indicator
Switching on
Warning! Remove, if present, the
removable label stuck on the inside of the
freezer compartment.
Insert the plug into the wall socket.
2 3
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its re-
frigerant circuit or insulation materials. The ap-
pliance shall not be discarded together with
the urban refuse and rubbish. The insulation
foam contains flammable gases: the appliance
shall be disposed according to the applicable
regulations to obtain from your local authori-
ties. Avoid damaging the cooling unit, espe-
cially at the rear near the heat exchanger. The
materials used on this appliance marked by
the symbol are recyclable.
Switching off
To switch off the appliance remove the mains
plug.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• press the temperature regulator until the
LED corresponding to the required temper-
ature lights up. Selection is progressive,
varying from to . The temperature indicated
by the LED is selected each time the button
is pressed.
Higher setting: +2°C
Lower setting: +8°C
A medium setting is generally the most suita-
ble.
6