Scope Of Delivery; Safety Instructions; Initial Use - Parkside PSH 3 A1 Betriebsanleitung

Switch on / off:
Energy supply:
UV / IR protection:
Operating temperature: -5 °C to +55 °C
Storage temperature:
Welding procedures:

Scope of delivery

1 Auto-Darkening Welding Helmet
1 Set of instructions for use

Safety instructions

Please carefully read the instructions for use and
follow the specified notices. Familiarise yourself with
the equipment, its proper use and the safety notices
using these instructions for use. All technical data
about this welding helmet is on the label, please
learn about this product's technical facts.
This device may be used by children aged 16
years and up, as well as by persons with reduced
physical, sensory or mental capacities, or lack-
ing experience and / or knowledge, so long as
they are supervised or instructed in the safe use
of the device and understand the associated
risks. Do not allow children to play with the prod-
uct. Cleaning and user maintenance should not
be performed by children without supervision.
The welding helmet with automatic darkening
is not suitable for laser and gas welding.
Never place the welding helmet on hot sur-
faces.
Never open the welding helmet. Never carry
out repairs on or modifications to the welding
helmet. These may only be carried out by
trained experts.
Please ensure that you have set the automatic
darkening before each welding procedure.
The safety visor should not be opened. It pro-
tects the filter from dirt and damage.
270752_Schweisshelm Automatik PSH 3 A1_content_FI.indd 7
Introduction / Safety instructions / Initial use
Fully automatic
Solar cell
DIN 16
-20 °C to +70 °C
MMA, MIG, MAG, TIG,
plasma cutting and
plasma welding
If the filter does not automatically darken, then
immediately end the welding procedure and
contact the manufacturer.
Only use the welding helmet in temperatures
between -5 °C and +55 °C. The filter's reaction
time will slow down if this temperature has not
been reached or is exceeded.
Clean the filter, the surface of the helmet and
the solar cells regularly.
Replace the protective visor if scratches or dam-
ages appear.
The welding helmet does not provide protection
against impact.
ATTENTION! Materials that come into contact
with the wearer's skin may cause allergic reactions
in people with sensitive skin.
ATTENTION! Eye protection can represent a
hazard for the wearer if it is worn over normal cor-
rective glasses due to the impact from high-speed
particles.
ATTENTION! If protection against high-speed
particles at extreme temperatures is required, the eye
protection chosen must be labelled with the letter
T directly after the letter for the impact intensity, i. e.
FT, BT or AT. If the letter for the impact intensity is
not followed by the letter T, the eye protection may
only be used against high-speed particles at room
temperature.

Initial use

Note: Only use the welding helmet with the rear
pane mounted .
4
Note: Keep the UV filter's sensors
clear.
Check that the welding helmet and the protective
screen are intact before each use. If the protective
screen has scratches, cracks or irregularities, it must
be replaced before use, as serious injuries may oc-
cur otherwise.
Remove the protective film from the inside and
the outside of the visor.
clean and
8
GB/IE 7
27.01.16 11:18