Technical Data; Scope Of Delivery; Safety Instructions - Parkside PSHL 2 A1 Montage-, Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Technical Data

z z
Filter cartridge size:
Field of vision:
Bright state:
Dark state:
Switching times
Bright to dark:
Dark to bright:
Switch on / off:
Energy supply:
UV / IR protection:
Operating temperature: -5 °C to +55 °C
Storage temperature:
Welding procedure:
Maximum service life:

Scope of delivery

z z
1 Auto-Darkening Welding Helmet
1 Set of instructions for use

Safety instructions

Please carefully read the instructions
for use and follow the specified
notices. Familiarise yourself with the
equipment, its proper use and the
safety notices using these instructions
for use. All technical data about
this welding helmet is on the label,
please learn about this product's
technical facts.
This device may be used by
„ z
children aged 16 years and up, as
well as by persons with reduced
physical, sensory or mental
110 x 90 x 10 mm
9.2 x 4.2 cm
DIN 4
DIN 9–DIN 13
0.23~0.72 ms
0.15~0.45 s
Fully automatic
Solar cell
DIN 16
-20 °C to + 70 °C
MMA, MIG, MAG,
TIG, plasma cutting and
plasma welding
approx. 6 years
Introduction/ Safety instructions
capacities, or lacking experience
and / or knowledge, so long as
they are supervised or instructed
in the safe use of the device and
understand the associated risks. Do
not allow children to play with the
product. Cleaning and user main-
tenance should not be performed
by children without supervision.
The welding helmet with auto-
„ z
matic darkening is not suitable
for laser and gas welding.
Never place the welding helmet
„ z
on hot surfaces.
Never open the welding helmet.
„ z
Never carry out repairs on or
modifications to the welding
helmet. These may only be
carried out by trained experts.
Please ensure that you have set
„ z
the automatic darkening before
each welding procedure.
The safety visor should not be
„ z
opened. It protects the filter from
dirt and damage.
If the filter does not automatically
„ z
darken, then immediately end the
welding procedure and contact
the manufacturer.
Only use the welding helmet in
„ z
temperatures between -5 °C and
+55 °C. The filter's reaction time
will slow down if this tempera-
ture has not been reached or is
exceeded.
GB/IE/NI 47