cramaro V2 Benutzerhandbuch Seite 53

In the learning mode, the control unit can only perform one function at a time.
The test function cannot be enabled unless the remote control code is first saved.
Once you enter the learning mode, the control unit will wait 10 seconds for a function to be executed (learning-test-
deletion).
If no action is launched, once the 10 seconds elapse, the control unit LED is activated with two consecutive pulses of
about 100 ms and the control unit will automatically exit the learning mode.
When the control unit exits the learning mode, it is automatically operational.
Deleting the control unit memory
The control unit's memory, used to recognise the remote controls, can be erased at any time.
Proceed as follows to erase the control unit's memory:
1. Turn the key to position ( 0 )
Wait for 5 seconds
2. Turn the key to position ( I )
3. Press the (red) mushroom-shaped emergency button to switch the device off and wait at least 1 second
4. Release the (red) mushroom-shaped emergency button to switch the device on again
5. Within 3 seconds after start-up, press buttons A and D on the remote control simultaneously until the control
unit LED lights up for about 100 ms (wait for about 3 s). This means that the control unit has entered the learning
mode.
6. Release buttons A and D of the remote control and wait at least 1 second; within 10 seconds, in the control
unit learning mode, activate the code delete function.
7. Deleting codes from the memory: press and hold buttons A and D on the remote control simultaneously until
the control unit LED is activated (wait for about 3 s) with two consecutive pulses of about 100 ms to indicate that
the control unit has successfully performed the function and exited the learning mode.
0 I UNCOVER COVER
0 I
UNCOVER COVER
53
CONTROL UNIT