cramaro V2 Benutzerhandbuch Seite 51

Remote control learning
Proceed as follows to recognise and save a new remote control:
1. Turn the key to position ( 0 )
Wait for 5 seconds
2. Turn the key to position ( I )
3. Press the (red) mushroom-shaped emergency button to switch the device off and wait at least 1 second
4. Release the (red) mushroom-shaped emergency button to switch the device on again
5. Within 3 seconds after start-up, press buttons A and D on the remote control simultaneously until the control
unit LED lights up for about 100 ms (wait for about 10 s). This means that the control unit has entered the
learning mode.
6. Release buttons A and D of the remote control and wait at least 1 second; within 10 seconds, in the control unit
learning mode, activate the save function of the remote control.
7. Saving the remote control code: hold down button A on the remote control until (you need to wait about 3
seconds) the control unit indicator light activates with two consecutive impulses of about 100ms to indicate
that the control unit has correctly carried out the learning function and has exited this mode.
Repeat the steps above to recognise and save a new remote control.
IMPORTANT NOTE: You can only add one remote control at a time.
The frequency of the remote control is 868MHz
Additional remote control (optional)
Should you wish to have several REMOTE CONTROLS to allow several operators to always have their own on hand, you
can also purchase them separately.
In order to be able to use the additional remote control(s), the control unit must be properly configured to recognise the
signals of the additional remote controls.
The control unit can be paired with up to 5 remote controls.
When pairing an additional remote control, the configuration inside of it related to the previous configuration is deleted
and the new remote control acquires the configuration of the control unit to which it has been paired.
0 I UNCOVER COVER
51
CONTROL UNIT
0 I
UNCOVER COVER