Herunterladen Diese Seite drucken

cramaro V2 Benutzerhandbuch Seite 52

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Test Function
The test function is useful to verify and diagnose the operation of the control unit and the correct connection of the
wiring during installation, even with the motor still disconnected.
After having connected the battery with the control unit, carried out the new remote control learning operation and
entered the test function, you can test system operation by selecting the tarpaulin opening or closing button (or selector);
if the red indicator light, located inside the control unit cover, is on, it means that the control unit and all the wiring is
functional and correct.
For the control unit to be made active and operative, it is MANDATORY to switch off and on by pressing the (red)
mushroom-shaped emergency button.
The procedure to perform this kind of test is as follows:
1.
Turn the key to position ( 0 )
Wait for 5 seconds
2.
Turn the key to position ( I )
3.
Press the (red) mushroom-shaped emergency button) to switch the device off and wait at least 1 second
4.
Release the (red) mushroom-shaped emergency button to switch the device on again
5.
Within 3 seconds after start-up, press buttons A and D on the remote control simultaneously until the control
unit LED lights up for about 100 ms (wait for about 10 s). This means that the control unit has entered the
learning mode.
6.
Release buttons A and D on the remote control and wait at least 1 second; within 10 seconds, in the control unit
learning mode, activate the test function.
7.
Activate the test function as follows: press and hold button D on the remote control until the control unit LED is
activated (wait for about 10 s) with two consecutive pulses of about 100 ms to indicate that the control unit has
successfully performed the function and exited the learning mode
8.
Select the cover opening or closing button (or selector) to verify operation. If the red LED inside the cover is on,
the control unit is running.
9.
Switch the control unit off and on to make it active and operative by pressing the (red) mushroom-shaped
emergency button.
0
I
UNCOVER
COVER
0
I
UNCOVER
COVER
52
CONTROL UNIT

Werbung

loading