SCS Sentinel SCS 1 Bedienungsanleitung Seite 29

Remote controls
Channels
Frequency - Maximum transmitted power
Power supply
Security
Photocells (option)
Detection Method
Sensing Range
Input Voltage
Response Time
Operation Indicator
Dimensions
Output Method
F- MAINTENANCE
F1- Motor
Conduct the following operations at least every 6 months. If in high intensity of use,
shorten the period in between.
Disconnect the power supply:
(1) Clean and lubricate the screws, the pins, and the hinge with grease.
(2) Check the fastening points are properly tightened.
(3) Make the wire connection are in good condition.
Connectthe power supply:
(I) Check the power adjustments.
(2) Check the function of the manual release.
(3) Check the function of photocells or other safety device.
F2- Remote control
o
29 CCO EN
2 x CR2016
0
4
433.92 MHz - power < 10 mw
2 batteries lithium CR2016 included
rolling code technology
Infrared Beam
MAX-IO m
12-24V AC/DC
< looms
RX: Red LEDOn (beam broken) / Off (beam aligned)
TX: Red LED On
63 x 63 x 30 mm
Relay Output