Scheppach HC65 Originalbetriebsanleitung Seite 28

Wear hearing protection.
Excessive noise can result in a loss of hearing.
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Sound power level L
wA
Sound pressure level L
pA
Uncertainty K
wA/pA
7. Unpacking
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m
WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
8. Before commissioning
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Prior to initial commissioning, remove the transport
plug (B) and fill the compressor pump housing with
oil as described in item 9.4.
• Check the device for transport damage. Report
any damage immediately to the transport company
which was used to deliver the compressor.
28 | GB
• Install the compressor near the point of consump-
tion.
• Long air lines and supply cables (extension cable)
should be avoided.
• Ensure that the intake air is dry and dust-free.
• Do not deploy the compressor in damp or wet areas.
• Operate the compressor only in suitable areas (well
ventilated, ambient temperature +5°C to 40°C).
97 dB
There must be no dust, acids, vapours, explosive
75 dB
gases or inflammable gases in the room.
2.41 dB
• The compressor is designed to be used in dry
rooms. It must not be used in areas where splashed
water is present.
• The oil level in the compressor pump must be
checked before commissioning.
• The compressor may only be used outdoor briefly
when the ambient conditions are dry.
• The compressor must always be kept dry and must
not be left outdoors after work is complete.
9. Assembly and operation
Attention!
Always make sure the device is fully assembled before
commissioning!
You require the following for assembly:
• 2 x open-ended spanner, 13 mm and 17 mm (not in-
cluded in the scope of delivery)
9.1 Fitting the wheels (fig. 3)
• Fit the wheels (4) provided as shown.
9.2 Mounting the foot (Fig. 4)
• Fit the foot (5) provided as shown in.
9.3 Installing the air filter (fig. 5, 6)
• Remove the transport plug (A) and screw the air
filter (1) to the device.
9.4 Replacing the transport lid (B) (Fig. 7)
• Remove the transport cap (B) of the oil filling open-
ing (16).
• Fill the compressor oil supplied into the compressor
pump housing and fit the enclosed oil plug (16) into
the oil filling opening (16).
www.scheppach.com