Scheppach HW2500 Original Bedienungsanleitung Seite 21

15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Fork does not lift
Fork lowers by itself
Fork does not lower
Operating lever does not
remain in "neutral" position
Possible cause
Not enough oil
Steel ball does not sit in the hydrau-
lic unit
Steel ball does not sit in the hydrau-
lic unit
Overpressure valve incorrectly
adjusted
Valve leaking
Guide pin broken
Fork frame broken
Lever (A) incorrectly adjusted
www.scheppach.com
Remedy
Check for leaks and top up oil
See "Cleaning the overpressure valve"
See "Cleaning the overpressure valve"
Adjust the overpressure valve with the
pressure adjustment screw until it no longer
lowers by itself.
Tighten valves
Replace the broken parts
Replace the broken parts
Adjust lever (A) using a slotted screwdriver
GB | 21