Scheppach HW2500 Original Bedienungsanleitung Seite 17

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• improper handling,
• noncompliance of the operating instructions,
• repairs by third parties, not by authorized service
technicians,
• installation and replacement of non-original spare
parts,
• non-intended use,
We recommend:
That you read through the entire operating instructions
before putting the machine into operation.
These operating instructions are to assist you in get-
ting to know your machine and utilize its proper appli-
cations.
The operating instructions contain important notes on
how you work with the machine safely, expertly, and
economically, and how you can avoid hazards, save re-
pair costs, reduce downtime and increase the reliability
and service life of the machine.
In addition to the safety requirements contained in
these operating instructions, you must be careful to ob-
serve your country's applicable regulations.
The operating instructions must always be near the
machine. Put them in a plastic folder to protect them
from dirt and humidity. They must be read by every op-
erator before beginning work and observed conscien-
tiously. Only persons who have been trained in the use
of the machine and have been informed of the various
dangers may work with the machine. The required min-
imum age must be observed.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of identically
constructed devices.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description
1. Control lever
2. Drawbar
3. Fork
4. Axle
5. Safety bolts
6. Clamping sleeve
7. Chain
A. Lever
B. Nut
C. Oil filler plug
D. Oil drain screw
3. Scope of delivery
• Drawbar
• Fork housing
• Axle
• Clamping sleeve
• Operating manual
4. Intended use
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufactur-
er will be liable for any damage or injuries of any kind
caused as a result of this.
To use the equipment properly you must also observe
the safety information, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the equipment have
to be acquainted with this manual and must be in-
formed about the equipment's potential hazards.
It is also imperative to observe the accident prevention
regulations in force in your area. The same applies for
the general rules of health and safety at work.
The machine may only be operated with original parts
and original accessories from the manufacturer.
The safety, operating and maintenance specifications
of the manufacturer, as well as the dimensions speci-
fied in the technical data, must be observed.
www.scheppach.com GB | 17