Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Breaking water pipes causes prop-
erty damage.
• Connect the device only to a
power outlet with a residual current
device (RCD) of rated residual cur-
rent no more than 30 mA.
• If the power cord of this device is
damaged, it must be replaced with
a specific cord.
• Only use accessories recom-
mended by PARKSIDE. Unsuit-
able accessories may cause elec-
tric shock or fire.
Residual risks
There will always be residual risks
even if you operate this device ac-
cording to the instructions. The fol-
lowing hazards may occur in connec-
tion with the type and design of this
device:
• Eye damage if no suitable eye pro-
tection is worn.
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear pro-
tection is not worn.
• Health injuries resulting from the
effect of hand/arm vibration in the
event that the tool is used over a
longer period of time or is not used
and maintained properly.
• Abrasions
WARNING! Danger due to elec-
tromagnetic field generated while the
tool is in operation. Under certain cir-
cumstances, this field may negat-
ively affect active or passive med-
ical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the
implant before operating the tool.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Do not in-
sert the plug into the outlet until the
device is fully prepared for use.
Control elements
Familiarise yourself with the operating
elements before using the device for
the first time.
Control panel (6)
• Speed button (2)
Set the rotational speed in 6 incre-
ments.
• Display (Speed level) (4)
• On/Off button (3)
• Switching on: Press
• Switching off: Press
• Unlock button (5)
• Unlock: Press
The speed level display lights
up.
If no further action follows, the
device is locked again after
20 seconds. The speed level dis-
play goes out.
Changeover switch (23)
Selecting the operating mode
CAUTION! Only change the oper-
ating mode when the sanding disc is
stationary!
GB
MT
31
Werbung
