Herunterladen Diese Seite drucken

Victoria Arduino VA 358 White Eagle Serie Gebrauchsanweisung Seite 21

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 51
On installation, the qualified electrician
must fit a circuit breaker switch as fore-
seen by the safety norms in force that
has a contact open distance that permits
the complete disconnection under con-
ditions of overload category III.
To prevent dangerous overheating, it is
advisable to fully extend the power sup-
ply cord.
Never block the intake and/or heat dissi-
pation grills, in particular those for the
cup warmer.
The user must never replace the unit's
power supply cord. If this cord is dam-
aged, turn off the unit and have it
replaced by a professionally qualified
technician.
Should it be necessary to replace the
power cord, this replacement operation
must only be performed by an authorized
service centre or by the manufacturer.
Should it be necessary to replace the
water inlet hose, use only a new hose.
The tube which is being replaced must
not be used any more.
Should you decide to stop using this
type of unit, we suggest you render it
inoperable by unplugging it and cutting
the power supply cord.
DANGER OF POLLUTION
Never dispose of the machine in the envi-
ronment: to dispose of the machine,
contact an authorized center or contact
the manufacturer for pertinent indica-
tions.
DANGER OF INTOXICATION
Once started the washing machine, do
not interrupt, the detergent residue may
remain inside the delivery unit.
DANGER OF BURNS
To facilitate aeration of the unit, position
the aeration portion of the machine 15
cm from walls or other machinery.
Be extremely careful when using the steam
nozzle. Never place your hands under the
nozzle and never touch it right after use.
Remember that to install, maintain,
unload and regulate the unit, the quali-
fied operator must always wear work
gloves and safety shoes.
The noise level of the machine is less
than 70db.
When the machine is left unattended for
a long period, close the water inlet tap.
The coffee machine must not be left
switched on without supervision, i. e.
without the presence of an operator.
Simonelli Group is not responsible for
any damage caused by malfunction of
the machine, in case this machine is left
on without the presence of the operator.
For machines connected to the mains
water supply, the minimum pressure
must be 2 bar and the maximum pres-
sure for correct machine operation must
not exceed 6,5 bar.
CAUTION
To prevent malfunctions of the levers,
make sure you have opened the tap
water passage (minimum 2 bars).
Do not pull and release levers before
having loaded the coffee.
Do not remove the filter holder when the
lever is pulled down.
21

Werbung

loading