Before First Use - Silvercrest SEMM 1470 A1 Bedienungsanleitung

Before first use
1) Clean the sieve holder
the drip grille
tank
as described in the section "Cleaning and care".
2) Place the appliance on a level and heat-resistant surface. Ensure that the
mains outlet is in easy reach.
3) Insert the drip tray
4) Insert the sieve holder
the appliance by inserting it at the "
turning it anticlockwise until the handle of the sieve holder
the "
5) Insert the plug into a mains power socket.
NOTE
6) Before first use, proceed as follows to clean the internal pipes:
–
fill the water tank
tank
–
Insert the water tank
–
Place a large cup on the drip grille
–
Set the milk nozzle
–
Switch the appliance on using the on/off switch
control lamps begin to flash. As soon as all the lamps light up perma-
nently the appliance has heated up.
–
Press the "Large" cappuccino button
coming out of the espresso outlet
permanently. Repeat this process 2x.
–
Switch the appliance off using the on/off switch
–
Empty the remaining water from the water tank
NOTE
► You should also clean the appliance as described here after long periods
out of use.
The appliance is now ready for use.
SEMM 1470 A1
, the measuring spoon
, the drip tray
, the milk tank lid , the water tank lid
and place the drip grille
together with the espresso sieve (
" symbol.
Remove the orange transport restraint from the bottom of the
water tank !
with water (approx. 200 ml), and also the milk
(approx. 100 ml).
and the milk tank
so that the milk nozzle
, the espresso sieves
, the tray for small cups
and the water tank
on it.
" marking on the appliance and then
in the appliance.
.
is pointing into the cup.
. Wait until water stops
and all control lamps light up
and the milk tank
GB │ IE │ NI
,
the milk
or ) into
is pointing to
(position I). All the
(position O).
.
│ 9 ■