Atlas Copco QMC41-100-I06 Sicherheitshinweise Seite 5

QMC41-100-I06
UK DECLARATION OF INCORPORATION
We, Atlas Copco Industrial Technique AB, SE-105 23
STOCKHOLM SWEDEN, declare under our sole responsi-
bility that this product (with name, type and serial number,
see front page) fulfils the following essential requirements of
The Supply of Machinery (Safety) Regulations 2008 S.I.
2008/1597:
S.I. 2008/1597, S.I. 2012/3032, S.I. 2016/1091
And that this partly completed machinery is in conformity
with the provisions of the following other UK Regulation(s):
This partly completed machinery must not be put into service
until the final machinery into which it is to be incorporated
has been declared in conformity with provisions of The Sup-
ply of Machinery (Safety) Regulations 2008 S.I. 2008/1597,
where appropriate.
The following (parts/clauses of) Designated Standards have
been applied:
BS EN 55014-1:2021, BS EN 55014-2:2021, BS EN
61000-6-2:2019, BS EN 61326-1:2021 (Class A), BS EN IEC
61000-3-2:2019+A1:2021, BS EN IEC
61000-3-3:2013+A1:2019+A2:2021, BS EN ISO
12100:2010, BS IEC 61010-1:2010+A1, BS IEC
61010-2-201:2017
The relevant technical documentation was compiled and was
communicated in accordance with The Supply of Machinery
(Safety) Regulations 2008 S.I. 2008/1597 part B of Annex
VII. Authorities can request the technical file in electronic
form from:
Aleksandra Duric, Product Compliance Manager, Atlas
Copco Industrial Technique AB, SE-105 23 Stockholm Swe-
den
Stockholm, 1 September 2023
Håkan Andersson, Managing Director
Signature of issuer
Authorised Representative UK
James McAllister, General Manager
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Safety
DO NOT DISCARD - GIVE TO USER
© Atlas Copco Industrial Technique AB - 9834 3502 00
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this prod-
uct.
Failure to follow all instructions listed below may result
in electric shock, fire, property damage and/or serious in-
jury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Intended Use
This product is designed for installing and removing threaded
fasteners in wood, metal or plastic.
No other use permitted.
Product Specific Instructions
Storage and Transport
Storage and transport
• The components should be stored at a dry place, and
should be protected from dust and aggressive media.
High variation of temperature should be avoided.
• Each connection should be removed before transport to
avoid breaking the connecting cables.
Use sufficient insulation of the shipping packet to protect
components against damage.
Installation
Installation safety
• Refer installation to qualified personnel only.
• Always connect the system to an earthed outlet.
• Always make sure that the mains plug is disconnected
and the controller is turned off before connecting or dis-
connecting the tool cable.
Safety Information
5