Operation; Assembly Of The Brushing Tools - Gloria Multibrush 230V Xl Betriebsanleitung

RZ_MULTIBRUSH_XL_985211-01.qxp_Text_GB 27.01.25 11:32 Seite 26

6.1 Operation

Figures 15 - 18
15
Slide the loop of the extension cable
into the designated cable strain relief
(C) in the handle (A) and fix it in the
designated clip.
NOTE!

The performance of the equipment
may decrease if unnecessarily long
extension cables (>25 m) are used.

If cable reels are used, unroll the
en tire cable.

The cross-section of the cable used
must be 1.5 mm

Make sure that the surface to be
cleaned is free from debris e.g. stones,
screws etc., which could be flung up.

Use an extension cable to connect the
device to a power outlet (230 V AC).
Speed recommendations for
GLORIA brushes
Position 1-2
Position 3-4
Position 5-6
CAUTION
RISK OF INJURY FROM ROTATING
BRUSHING TOOL!

Never start the device in a tilted posi-
tion!

Do not start or operate device if
bystanders are in the danger zone.

Never put your hands or feet near to
the rotating brushing equipment!

Never clean if others, in particular
children or animals, are in the area!

Never use the device in the rain.
16
You can regulate the speed of the
brush by pressing the speed control on
the adjustment wheel (U).
17
Hold the device securely by the handle
(A) and additional handle (F) and
switch on the device. To switch ON,
firstly press and hold the lock-off
2 .
soft brushes (wood brush)
harder brushes (stone brush)
joint brush (wire brush)
button (B) for ON/OFF safety switch
(E). Then press the ON/OFF safety
switch (E) and keep it pressed.
18
Always place the device parallel on the
ground which is to be cleaned.

In case of work interruptions or
danger, release the ON/OFF safety
switch (E) immediately.
6.1.1 Assembly of the brushing
tools
Figures 19 - 25
CAUTION
RISK OF BURNS CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or compo-
nents can still be very hot and may
cause burns.
It is therefore important to observe
the following safety instructions:

Wear protective gloves during
assembly!
Disassembly of surface brush followed by
assembly of the joint brush

Switch off the device and disconnect
the power cord (D) from the power
supply.
19
Open the locking device (L)
guide arm (N) as shown in the illustra-
tion. With the locking device (L) actua-
ted, remove the guide arm (N) with the
safety guard (P).
20
Remove both surface brushes and the
brush connector (S).
21
Now open the locking device (L)
the XL-drive arm (Q), as shown in
the illustration and remove, with the
lock applied, (L) the XL-drive arm (Q)
with safety guard (P).

The surface brushes are now success-
fully dismantled.
22
Put the guiding wheel (J), as shown in the
illustration, on the steering side of the
motor/gear unit (M). Now slide the lock
26
of the
of