Maintenance; Storage; Troubleshooting; Possible Cause - Parkside Performance Psspa 20-Li D3 Originalbetriebsanleitung

NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.

Maintenance

The device is maintenance free.

Storage

Always store the device and accessories:
• clean

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with interrup-
tions
Poor sawing performance
Saw blade quickly becomes
blunt
• dry
• protected against dust
• In the case provided (34)
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0 °C and 45 °C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).

Possible cause

Rechargeable battery (9) not
inserted
On/Off switch (2) is broken contact the service centre.
Rechargeable battery (9) dis-
charged
Defective motor
Internal loose contact
On/Off switch (2) is broken contact the service centre.
Saw blade (16/17) unsuit-
able for the workpiece to be
processed
Saw blade (16/17) blunt
Low battery power
Incorrect sawing speed
Saw blade (16/17) unsuit-
able for the workpiece to be
processed
Too much pressure applied
GB
Troubleshooting
Inserting the battery,
p. 37
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
contact the service centre.
contact the service centre.
Use a suitable saw blade
(16/17)
Use a new saw blade (16/
17)
Charge the battery (see the
separate operating instruc-
tions for the rechargeable
battery and charger)
Adjust sawing speed
Use a suitable saw blade
(16/17)
Reduce the pressure
MT
39