Parkside Performance PSSPA 20-Li D3 Originalbetriebsanleitung Seite 37

0 Metal
1 Plastic pipe
2 Thin wood
3 Thick wood
Plunge sawing
Requirements
• Soft materials such as wood, aerated
concrete, plasterboard etc.
• Mitre angle: 0°
• Short saw blade mounted
Procedure (Fig. F)
1. Place the device with the front edge of
the footplate (12) on the workpiece.
The saw blade (16) does not touch the
workpiece.
2. Turn the device on. Wait until the max-
imum stroke rate has been reached.
3. Press the saw blade (16) into the work-
piece until the footplate (12) rests on
the workpiece.
4. Continue sawing along the cutting line.
General Information
With this order, you work safely with the
sabre saw and achieve a good result:
1. Clamp the workpiece. Use a clamping
device for small workpieces.
2. Draw a line to specify the direction in
which the saw blade is guided.
3. Hold the device securely by the
handle.
4. Set the stroke rate.
5. Set the mitre angle.
6. Set the stroke strength.
7. Turn the device on.
8. Wait until the device has reached its
full stroke rate.
9. Place the footplate on the workpiece.
10. Slowly move the device along the
marked line, pressing the footplate
firmly down onto the workpiece.
11. Do not apply too much pressure in the
cutting direction. Let the device do the
work.
12. Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
NOTICE! Risk of damage! An incorrect
battery can damage the device and bat-
tery.
Inserting the battery
1. Push the battery (9) along the guide in-
to the battery holder (8).
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release (32)
on the battery (9).
2. Pull the battery out of the battery hold-
er (8).
Switching on and off
Switching on
1. Insert the rechargeable battery (9) into
the device.
2. Press the unlock button (3).
The LED work light (22) lights up, the
device is unlocked.
3. Set the stroke rate with the stroke rate
button (26).
4. Press the on/off switch (2)
5. Wait until the device has reached its
full stroke rate.
You can guide the device with the base-
plate (12) against the workpiece.
Switching off
1. Press the on/off switch (2)
GB MT
37