Checking The Battery Charge Level; Charging The Battery; Operation; Information On Sawing - Parkside Performance Psspa 20-Li D3 Originalbetriebsanleitung

GB MT
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (33) next to the
charge level indicator button (31) on
the battery (9).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (9) when only the
red LED on the charge level indicator
(31) is illuminated.

Charging the battery

See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (9) from the
device.
2. Push the battery (9) into the charging
slot of the battery charger (30).
3. Connect the battery charger (30) to a
power outlet.
4. After charging, disconnect the battery
charger (30) from the mains.
5. Pull the battery (9) out of the battery
charger (30).
36
Meaning
Battery partially
charged
Battery needs to be
charged
Control LEDs on the charger (30):
green red
lights up —
— lights up
— flashes
flashes flashes

Operation

Information on sawing

Selecting a stroke rate
The stroke rate can be adjusted in 6 steps
with the stroke rate button (26). Start with
a low stroke rate. As a rule of thumb:
Material
Hard
Soft
If the automatic stroke rate A is set, the
device adjusts the stroke rate to the hard-
ness of the material.
Selecting the pendulum motion
The larger the pendulum motion, the faster
your progress.
The optimal pendulum motion can be es-
tablished through practice; the following
settings are recommended:
• For thin material, hard material (e.g.
metal) or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion: Level 0 or 1.
• Soft material (wood, plastic, etc.): Level
2 or 3
The label shows examples on the setting:
Meaning
• Battery is fully
charged
• stand-by (No
battery inserted)
Battery is charging
Battery is over-
heated
Battery is defective
Stroke rate
Low
High