Overtemperature Display; Attaching And Removing The Saw Blade; Using The Parallel Guide - Parkside Performance Psspa 20-Li D3 Originalbetriebsanleitung

GB MT
LEDs
red, orange, green Battery charged
red, orange
red
• Stroke rate button (26); Stroke
rate display (25)
Set the stroke rate in 6 levels and auto-
matic:
• 1 lowest stroke rate
• 6 highest stroke rate
• A automatic stroke rate adapted to
the load

• Overtemperature display (27)

Lights up if the battery is too hot.
• Wait until the light goes out.
Switch (dust blower function) (7)
Blower function for chip-free cutting line
⭠
enable
Lever (6)
Bevel cutting, p. 35
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when
handling the saw blade.
Requirements
• The saw blade is suitable for the re-
spective material.The scope of de-
livery for the device includes large-
toothed saw blades for wood and a
fine-toothed saw blade for metal and
plastic.
34
Meaning
Battery partially
charged
Battery needs to be
charged
⭢
disable
• The chuck is free of splinters or other
material residue.
Installing the saw blade (Fig. B)
1. Turn the release of the chuck (14) as
far as possible. Keep the release of the
chuck fixed in this position.
2. Place the saw blade (16/17) into the
chuck (21).
3. Release the release of the chuck (14)
los.
4. Make sure that the saw blade (16/17)
is attached correctly and the teeth are
pointing in the cutting direction.
Removing the saw blade (Fig. B)
Hold the device in a way that no persons
in the vicinity are injured by the ejected
saw blade.
1. Hold the saw blade (16/17) firmly.
2. Turn the release of the chuck (14) as
far as possible.
The saw blade (16/17) is ejected.
If the saw blade is not ejected: Hold
the release of the chuck and pull the
saw blade from the chuck.
3. Release the release of the chuck (14)
los.

Using the parallel guide

The parallel guide can be fitted on both
sides of the tool.
Fitting the parallel guide (Fig. C)
1. Loosen the retaining screws (20) if ne-
cessary.
2. Push the parallel guide (28) into the
holders (18).
3. Retighten the retaining screws (20).
Removing the parallel guide
(Fig. C)
1. Loosen the retaining screws (20).
2. Pull the parallel guide (28) out of the
holders (18).