DeFelsko PosiTector 6000 Bedienungsanleitung Seite 3

Press the button to power up the Gage. To conserve battery
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in
significantly faster— convenient when moving between parts or
locations. The gage will completely power off after 4 hours of
inactivity. Alternatively, select
All settings are retained.
Remove the protective rubber cap (if supplied) from probe.
Power-up Gage by pressing the center navigation button
Verify accuracy and adjust if necessary (pg. 3).
Place the probe FLAT on the surface to be measured.
HOLD STEADY. When a valid measurement is obtained,
the Gage BEEPS twice and the measurement is displayed.
Lift probe AT LEAST 2 INCHES (5 cm) from the surface
between measurements - OR - leave probe on the surface
in the same location for continuous measurements.
To access the Menu, power-up the gage, then press the center
navigation button
used to navigate the menu. If desired, touch screen functional-
ity can be disabled within the Setup menu (See
Select a menu option by touching it, or use the
tons to highlight the desired option and press
On menus longer than one page, the current page number is
displayed below the menu name. Navigate between pages
using when the first menu item is selected, or
last menu item is selected. If using touch, navigate between
pages by touching
. Either the keypad or touch screen can be
or , or by swiping up or down.
1
, the gage powers up
from the main menu.
and
to select it.
.
, pg. 8).
but-
when the