DeFelsko PosiTector 6000 Bedienungsanleitung Seite 15

Before returning the instrument for service...
Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
Examine the probe tip for dirt or damage. The probe should
move up and down freely.
Perform a
Place a plastic shim onto bare metal (steel or non-ferrous),
depending upon whether you have an " " or " " probe) and
attempt a measurement. (see
If issue is not resolved,
gage body and re-attempt measurements.
If these steps do not resolve the issue and the Gage must be
returned for service, please follow the instructions provided at
www.defelsko.com/service.
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth
on its website: www.defelsko.com/terms
© 2024 DeFelsko Corporation USA All Rights Reserved
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiSoft, and PosiTector are trademarks of DeFelsko Corporation registered in
the U.S. and in other countries. Other brand or product names are trademarks or registered
trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate. De-
Felsko is not responsible for printing or clerical errors.
(pg. 6).
(pg. 12) your
, pg. 3)