DeFelsko PosiTector 6000 Bedienungsanleitung Seite 6

A
value, can be performed in
the probe and adjust to "0" using the
NOTE:
A
when
(pg. 5) to perform this adjustment.
to is to average 3 to 10 measurements on the uncoated
part.
shim of known thickness placed on the uncoated part. Lift the
probe and adjust to the shim thickness using the
buttons.
NOTE: A
not be performed when
Disable
A preferred method to
ments of a shim of known thickness placed on the uncoated
part.
over rough or blasted substrates without access to the
uncoated representative substrate. Predefined
values can be selected according to the blast profile height in
accordance with ISO 19840. Alternatively, a custom Zero
Offset can be entered. The Zero Offset value is subtracted
from each reading.
NOTE:
If the uncoated representative substrate is available,
performing an
(above) is recommended for best accuracy.
1
also known as an offset or correction
Measure the uncoated part. Lift
is enabled (default). Disable
(pg. 5) to perform this adjustment.
is to average 3 to 10 measure-
- Useful when measuring coating thickness
4
:
and buttons.
cannot be performed
A preferred method
Measure a
and
is enabled (default).
can-